Toyota 1991 CAMRY Body Section Repair Manual page 99

AR-8
BODY PANEL UNDERCOATING AREAS
NOTE:
1. First wipe off any dirt, grease or oil with a rag soaked in grease, wax and silicone remover.
2. Cover the surrounding areas with masking paper to avoid coating unnecessary areas. If other
areas are accidently coated, wipe off the coating immediately.
3. Apply the first coating of undercoat to all welded areas and panel joints, then apply a second
coat over entire area.
4. Do not coat parts which become hot, such as the tailpipe, or moving parts, such as the propeller
shaft.
5. Besides the locations described below, apply undercoating to all weld points under the body to
insure corrosion prevention.
6. Be sure to seal the edge of the flange of the member and bracket with undercoating.
7. If undercoat is damaged by peeling, cracks, etc., be sure to repair as necessary.
REFERENCE: Referring to the notes above, undercoating should be applied according to the specifications
for your country.
ANTI-RUST TREATMENT