Vermont Castings Stardance 3070 Homeowner's Installation And Operating Manual page 35

All Models
21. Replace burner. Slide the burner in at an angle with
left side lower than the right side. Slide the left side
onto the injectors, making sure the burner leg
remains at a 90° angle to the base. Lower the right
hand side down in to place. Make sure the burner is
as far left as possible and the injector shoulders are
inside the burner.
NOTE: It is very critical to keep the left burner leg,
which holds the injectors, at a 90° angle to the base.
(Fig. 66) This keeps the orifices aligned with the
tubes inside burner. Failure to do so could affect the
flame appearance and performance of the unit.
22.Place conversion label on valve.
23.Reinstall the right and left log bracket assembly.
24.Reinstall the rear log bracket.
25.Replace logs.
26.Replace glass and stove front.
Conversion is complete.
Kit #
000-5021
000-5011
Kit #
000-5022
000-5012
20003456
Vermont Castings Stardance Direct Vent/Natural Vent Gas Heaterr
Table 2. Injector Orifice Size Matrix
Conversion to Natural Gas
Front Part #
#54 / .055" 30000514
Conversion to LP
Front Part #
#69 / .029" 30000513
90°
Fig. 66 Remove and replace injector orifices.
Rear Part # Minimum
#44 / .086" 30000334
Rear Part # Minimum
#54 / .055" 30000514
Left Burner Leg
Injector Orifices
Input (BTU/h)
Maximum
19,000 28,000
Input (BTU/h)
Maximum
20,000 28,000
ST353a
35