Fuel Conversion Instructions - Vermont Castings Stardance 3070 Homeowner's Installation And Operating Manual

WARNING! This conversion kit shall be installed
by a qualified service agency in accordance with
the manufacturer's instructions and all applicable
codes and requirements of the authority having
jurisdiction. If the information in these instruc-
tions is not followed exactly, a fire, explosion or
production of carbon monoxide may result
causing property damage, personal injury or loss
of life. The qualified service agency is respon-
sible for the proper installation of this kit. The
installation is not proper and complete until the
operation of the converted appliance is checked
as specified in the manufacturer's instructions
supplied with the kit.
CAUTION: The gas supply shall be shut off prior
to disconnecting the electrical power, before
proceeding with the conversion.
Gas Supply Inlet
Fig. 58 Attach the gas line to the left side of the valve.
Conversion Precautions
Before proceeding, turn control knob on valve to OFF
and turn gas supply OFF. Turn OFF any electricity that
may be going to the appliance.
Conversion Procedure
1. Remove stove front. Lift stove front up and then
swing bottom out and away to disengage from the
stove body. (Fig. 67, Page 36)
2. Swing open the swiveling latches at the top left and
right corners of the glass frame. (Fig. 68, Page 36)
3. Pull the top edge of the glass and frame assembly
away from the firebox face. Place the assembly out
of the way on a flat, padded surface such as a
counter protected by a towel.
4. Remove the logset from the firebox.
5. Remove the rear log bracket by unfastening the
screw. (Fig. 59)
6. Remove the right and left log bracket assembly by
unfastening the two screws which hold the burner in
place. (Fig. 59)
20003456
Vermont Castings Stardance Direct Vent/Natural Vent Gas Heaterr

Fuel Conversion Instructions

Main
Gas Line
ST226
Remove Screws
Fig. 59 Remove rear log bracket and left and right log
bracket assembly.
7. Hold the burner at the right hand side and lift to clear
the right burner leg. Then pull to the right to clear the
injectors on the left hand side.
8. Remove injector orifices from left burner leg using
1/2" wrench. (Fig. 66)
9. Install conversion orifices. (Refer to Table 2)
Models 3070, 3071 (R Models) Only
10. Remove cap from Hi-Lo knob. This can be accom-
plished by lifting the plastic cap off the screw. (Fig.
60)
11. Remove the screw from center of Hi-Lo knob with
small screwdriver turning counterclockwise. (Fig. 60)
Cap
Lift Open
Hi-Lo
Knob
Fig. 60 Remove center screw from Hi-Lo knob.
12.Insert blue painted screw when converting to natural
gas and red painted screw when converting to LP.
13. Tighten screw (do not over tighten), replace cap.
14. Locate pilot. (Fig. 59)
15. Replace pilot orifice.
Rear Log Bracket
Pilot
Left & Right Log
Bracket Assembly
ST350
Center Screw
CO100
33