Complete The Assembly - Vermont Castings Stardance 3070 Homeowner's Installation And Operating Manual

Vermont Castings Stardance Direct Vent/Natural Vent Gas Heater
Remove Screws
Fig. 43 Remove rear log bracket and left and right log
bracket assembly.
8. The air shutter is located on the bottom of the burner
to the left. (Fig. 41) Unfasten the two nuts holding
the shutter in place. The shutter may be adjusted
between the factory adjusted 1/2" to fully open.
Reassemble the shutter to allow the rear injector air
inlet to close from the minimum 1/2" opening to fully
open. (Fig. 45) You may have to try more than once
to find the correct air shutter opening for best results
depending on your altitude.
Air Shutter
(Original Position)
See Table 1
Fig. 44 Air shutter in original from-the-factory position.
Front Injector
Air Inlet
Rear Injector Air Inlet
Fig. 45 Air shutter adjusted.
24 24
Rear Log
Bracket
Pilot
Left & Right Log
Bracket Assembly
Burner
ST352
Air Shutter
(May be adjusted up to fully open)
Burner
ST351
9. Refasten the two nuts and assemble the burner into
the unit by sliding the burner in at an angle with the
left side lower than the right side. Slide the left side
onto the injectors. Lower the right hand side down
into place. Make sure the burner is as far left as
possible and the injector shoulders are inside the
burner. NOTE: It is very critical to keep the left
burner leg, which holds the injectors, at a 90° angle
to the base. (Fig. 46) This keeps the orifices aligned
with tubes on the inside of the burner. Failure to do
so could affect the flame appearance and perfor-
ST350 mance of the unit.
10.Refasten the right and left log bracket assembly.
11.Refasten the rear log bracket.
12.Replace logs.
13.Replace glass and stove front.
Follow lighting instructions on page 27. Check flame
color appearance. NOTE: Allow stove to burn for at
least 1/2 hour to establish full flame color.
Should color need further adjustment, repeat steps 1 -
12 for air shutter adjustment.
Fig. 46 Be sure to maintain 90° angle at left burner leg.

Complete the Assembly

• Open the swiveling latches (cams) on the top left
and right corners of the glass frame.
• Position the glass and frame against the firebox by
placing the bottom edge on the brackets on the
bottom face of the firebox.
• Swing the assembly against the firebox, and close
the latches firmly against the pins protruding from
the firebox top.
Left Burner Leg
Injector Shoulder
90°
ST353
20003456