2.19 Toner Sensor (513), Laser Unit [LSU] (512), SNS3 PC Board (535)
(2)
(4)
(6)
(9)
(8)
(1) Remove the Transmit Guide Assembly (Refer to 2.5).
(2) 2 Screws (19).
(3) Remove Ground Wire (542).
(4) Remove the CCD Shield Plate (533).
(3)
(5) 1 Screw (19).
(6) Disconnect Connector CN84 on the SNS3 PC Board.
(5)
(7) Remove the Toner Sensor Spring Plate (506) Assembly.
(7)
Note:
When reinstalling, make sure that the Toner Sensor Spring
Plate is inserted into the 2 notches in the main frame as
shown in the illustration.
(8) Remove the Toner Sensor (513).
(9) Disconnect the Connector on the Toner Sensor.
Disassembly Instruction
45