Panasonic UF-585 / 595
5.9.3
Recovering F-ROM Firmware Update Failure
If the Firmware Update is interrupted before completion, the machine will not be able to progress into the Standby Mode and the
LCD display will remain Blank. If this happens, please follow the steps described below to recover from a failed firmware update.
(2)
Control Panel Unit
(4)
(5)
182
Memory Card Cover
(3)
(1) Unplug the Power Cord.
(2) Remove the Memory Card Cover.
(3) Insert the Flash Memory Card gently into the card slot with
the Panasonic logo facing to the outside of the machine.
Caution:
Installing the Flash Memory Card in the wrong direction may
damage the connecting pins inside the machine.
(4) Open the Control Panel Unit.
(5) Activate the Read Point Sensor with your finger and plug
in the Power Cord.
(6) Wait approximately 10 seconds, release the Read Point
Sensor and close the Control Panel Unit (ADF).
(7) Allow the unit to complete the Firmware Update (approx.
1-minute). When completed, the unit will reboot and
progress to the Standby Mode.
(8) Unplug the Power Cord.
(9) Remove the Flash Memory Card.
(10) Re-install the Memory Card Cover.
(11) Plug in the Power Cord.
(12) Perform Parameter Initialization (see page 173).