Collating Copies/Prints
The Finishing modes can be selected to collate the outputs in various ways, either
by pages or copy/print sets.
IMPORTANT
•
For information on the modes which cannot be set in combination with this mode, see
3
"Combination of Functions Chart," on p. 9-6.
•
The Finishing modes cannot be set if envelopes, transparencies, tracing paper, or labels
is selected.
•
If you set the Staple or Hole Punch mode, the side of the paper which is printed on will
always be output face down.
•
The Hole Punch mode is available only if the optional Finisher-Y1 or Saddle Finisher-Y2
and Puncher Unit-M1 are attached to the Color imageRUNNER C3480/C3480i/C3080/
C3080i. (The optional Finisher-Y1, Saddle Finisher-Y2, and Puncher Unit-M1 are not
available for the Color imageRUNNER C2550.)
•
The Saddle Stitch mode is available only if the optional Saddle Finisher-Y2 is attached to
the Color imageRUNNER C3480/C3480i/C3080/C3080i. (The optional Saddle
Finisher-Y2 is not available for the Color imageRUNNER C2550.)
NOTE
•
For information for the optional finishers, see Chapter 3, "Optional Equipment," in the
Reference Guide.
To cancel this setting, press [Finishing] ➞ [Cancel].
•
3-32
Collating Copies/Prints