2
1
3
1-24
Reserved Copying
Place your originals ➞ set the desired copy modes ➞ press
[Paper Select] ➞ [Stack Bypass Settings].
If you selected [Transparency], press [Overhead Project. Type] and select either
[Transmissive] or [Reflective].
Normally, when reserved copying is not being set, the Stack Bypass Settings
screen is automatically displayed when paper is loaded into the stack bypass.
Select the desired paper size.
NOTE
•
If you select [Envelope], [Tracing Paper], [Transparency], or [Labels], you cannot
specify any Finishing modes (Collate, Group, or Staple).
•
If Stack Bypass Standard Settings in Common Settings (from the Additional
Functions screen) is set to 'On', and the paper size/type have been stored, the
selected paper size/type are displayed on the screen. (See Chapter 4,
"Customizing Settings," in the Reference Guide.)
● If you want to select a standard paper size:
❑
Select the desired paper size ➞ press [Next].
NOTE
To select an A or B series paper size, press [A/B-size].
❑
Select the desired paper type ➞ press [OK].
If you want to adjust the thickness of the toner applied to the paper, press
[Plain Ppr Print Set.]. If too much toner is being applied to the paper, press
[Thin]. If not enough toner is being applied to the paper, press [Heavy].
If the desired paper type is not displayed, press [Detailed Settings] ➞ select
the paper type from the list ➞ press [OK].
If you are copying onto the back side of a previously printed sheet, press [2nd
Side of 2-Sided Page].