3
Press [Start Scan].
IMPORTANT
Confirm that the original is placed on the platen glass.
4
Designate the area using the edit pen.
IMPORTANT
You cannot designate a rectangular area and a polygonal area at the same time.
● To designate a rectangular area with two points:
❑
Designate two opposing points with the edit pen.
You can designate up to four different areas.
● To designate an area with multiple points:
❑
Press [Multi-point] ➞ specify the area with the edit pen.
❑
After designating the last point, press [Fix Multipoints].
You can designate up to 10 points.
IMPORTANT
•
If you select [Multi-point], only one area can be designated at a time.
•
An area that is designated by selecting [Multi-point] cannot be modified using
(numeric keys).
5
Press [Framing] or [Blanking].
Details of each item are shown below.
[Framing]: Copy only the contents of the designated area while discarding the
rest of the original.
[Blanking]: Copy the original by blanking out the contents of the designated area.
If you want to use different settings for different areas, select the area by pressing
the appropriate area key ➞ select [Framing] or [Blanking].
6
Press [Preview] ➞ check the designated area ➞ press [Done].
7
Press [Next] ➞ select [Shift center] or [Do not shift center].
If only [Blanking] is selected, this step is unnecessary. Skip to step 8.
Process/Layout Settings
7
-
7-69