Initial-Screen Selection; Power-On) (B038) - Hitachi SJ700B Series Instruction Manual

Chapter 4 Explanation of Functions
(4) Basic display mode
The monitor displays basic parameters. (The monitor display is the factory setting.)
The following table lists the parameters that can be displayed in basic display mode:
No. Code displayed
1 d001 to d104
2 F001
3 F002
4 F003
5 F004
6 A001
7 A002
8 A003
9 A004
10 A005
11 A020
12 A021
13 A022
14 A023
15 A044
16 A045
17 A085
18 b001
19 b002
20 b008
21 b011
22 b037
23 b083
24 b084
25 b130
26 b131
27 C021
28 C022
29 C036
4.2.85 Initial-screen selection (selection of the initial screen to be displayed after
power-on)
The initial-screen selection function allows you to specify the screen that
is displayed on the digital operator immediately after the inverter power is
turned on. The table below lists the screens (items) selectable. (The
factory setting is "01" [d001].)
To adjust the screen selection setting of your SJ700 series inverter to an SJ300 series inverter, select "00"
(the screen displayed when the STOP/RESET key was last pressed).
Item

Initial-screen selection

Note: When "00" (the screen displayed when the STR key was last pressed) has been selected, the
monitor displays code "*---" (entry to a group of functions) if the functional item displayed last is not
"d***" or "F***".
(Example) If the inverter power is turned off immediately after the setting of "A020" has been
changed, the monitor will display "A---" as the initial screen after the next power-on.
Monitoring indication
Output frequency setting
Acceleration (1) time setting
Deceleration (1) time setting
Keypad Run key routing
Frequency source setting
Run command source setting
Base frequency setting
Maximum frequency setting
[AT] selection
Multispeed frequency setting
Multispeed 1 setting
Multispeed 2 setting
Multispeed 3 setting
V/F characteristic curve selection, 1st motor
V/f gain setting
Operation mode selection
Selection of restart mode
Allowable under-voltage power failure time
Selection of retry after trip
Retry wait time after trip
Function code display restriction
Carrier frequency setting
Initialization mode (parameters or trip history)
Overvoltage suppression enable
Overvoltage suppression level
Terminal [11] function
Terminal [12] function
Alarm relay active state
Function code
b038
Item
Data
00 Screen displayed when the STR key was pressed
last (equivalent to the setting on SJ300)
01 d001 (output frequency monitoring)
02 d002 (output current monitoring)
03 d003 (rotation direction minitoring)
04 d007 (Scaled output frequency monitoring)
05 F001 (output frequency setting)
4 - 78
Related code
b038: Initial-screen selection
Description