Table of Contents
Advertisement
4.11.2.
Table 4.0-5 VIC Video Source Cable Connections
VIC Input
Connectors
Wide Bandwidth
RGBHV
Graphics Enhancer
RGBHV
Quad RGBHV Video
Mux (multi-port)
Component HDTV
(YP
P
) Input
b
r
Module
Quad Standard
Decoder Module
(with Line Doubler)
4.11.3.
HJT Model 100 User's Guide
Connecting VIC Source Cables
Connect the source cables to the input connectors as marked on the rear
of the VIC.
Connect the RGBHV cables to the appropriately marked input jacks
(Figure 4.0-20 on page 4-44).
Connect the RGBHV cables to the appropriately marked input jacks
(Figure 4.0-20 on page 4-44).
Connect the RGBHV cables to the input connectors on the port(s) to be used
(Figure 4.0-21on page 4-44).
Connect the three (3) input cables to the appropriate input jacks
(Figure 4.0-22 on page 4-44).
NOTE: Red, Green, and Blue input jacks are in a different order from the
RGBHV VIC with Green at the left, Blue in the middle, and Red on the right.
The HDTV YP
P
VIC uses the same circuitry and input jacks to process
b
r
two (2) different type of inputs; the GBR input and the YP
Only one (1) of these inputs may be selected at any one time.
The selection of one of these inputs is made by editing the second number in
the VIC column (see editing VICs following) and using separate channels
for their sources.
There are two (2) distinct input connections (Figure 4.0-23 on page 4-45).
The input connector at right, labeled Video is for Composite Video (C-VID).
The two (2) connectors at left, labeled Y and C are for S-Video.
The selection of one of these inputs is made by editing the second number in
the VIC column (see editing VICs, below) and using separate channels for
their sources.
VIC Editing
The VIC column in the C
sources coming into the projector follow the correct path through the
correct VIC input.
To edit a VIC:
1. Select C
HANNELS
2. Select a blank channel.
NOTE: If there are no blank channels, don't edit an existing channel
for a new VIC—press M
from a blank channel.
3. Press the M
ODE KEY
4. Select E
.
DIT
5. Press the right arrow to move to the VIC column, then press E
Cable Connections
must now be edited so the
HANNELS MENU
from the M
M
.
AIN
ENU
and cut the entire channel entry and start
ODE
to display the E
DIT
Chapter 4—Setup Adjustments
P
input.
b
r
submenu.
.
NTER
4-41
Advertisement
Table of Contents
