Table of Contents
Advertisement
Chapter 4—Setup Adjustments
4.11.2. Connecting VIC Source Cables...............................................................4-40
4.11.3. VIC Editing ..............................................................................................4-40
4.11.4. VIC Settings ............................................................................................4-42
4.12. Updating Software ...........................................................................................4-44
This chapter assumes the operator is using a remote control and accessing setup
functions through the menu tree. All instructions are given with reference to using the
menu tree for setup functions. If using a PC or laptop computer to control the projector
refer to Table 3.0-10 on page 3-23 for the equivalent key functions.
Chapter 3 covered mainly operation for projectors that are already positioned, set up,
and ready for operation. This chapter covers the complete projector setup procedures.
Prior to starting the procedures in this chapter, the operator should review Chapter 3 to
become familiar with navigating the menu and using the remote control keys.
Prior to performing any adjustments, allow the projector to warm up for at least 60 minutes.
4.1. Setup Preparation
In the Timing and Geometric adjustments below, Green is the active and
on-screen color. Red and Blue are hidden because they track on Green.
When the Timing and Geometric adjustments in this section are finished,
Red and Blue is then centered to match Green and converged onto Green in the
Convergence procedures. To hide Red and Blue, toggle the RGB key to R
press H
displayed on the screen. Toggle the RGB
To avoid redundancy in the procedures in this chapter, some general information,
instructions, phrases, and definitions are given below.
Table 4.0-1 Setup Phrases, Definitions, and General Information
Phrase
R, G, or B
Toggle to
Red/Green/Blue
Access an item
from the menu
Hide a color
Active
Inactive
Highlighted
4-2
, then toggle to B
IDE
LUE
Red, Green or Blue.
Pressing the RGB key repeatedly until the desired color is selected by
observing the highlight on the RGB window on the screen.
Pressing M
and/or E
ENU
then pressing the number of the menu or item desired.
Highlight color with the RGB toggle, then press the H
The active channel is the one on the screen.
The inactive channel has either no input connected or
no signal coming in to its input or is not active (on screen).
The channel selected by pressing a channel number
but not yet activated by pressing E
Pressing the channel number highlights the channel on the channel
list.
Pressing E
makes it active on screen.
NTER
Figure 4.0-1on page 4-7 illustrates an active and highlighted
channel.
and press H
. Green is now the only color
IDE
to highlight G.
KEY
Definition
keys to display the M
SCAPE
.
NTER
Hughes-JVC Technology Corporation
,
ED
M
, and
AIN
ENU
key.
IDE
Advertisement
Table of Contents
