Appendix - Hughes JVC CB100 User Manual

Appendix B—Configuration Data
Export / Import Procedures (Rev 1.0.0)
HJT Model 100 Projector Appendix B defines the steps to perform a Configuration Data
Export and Import from the projector to a host computer. The host computer can be any
system that has RS232 download and upload capability, including an IBM-PC
compatible, an Apple MacIntosh, or a UNIX system—the following procedures are for an
IBM-PC running the W
for communication with the projector. Other terminal emulation programs can be used
(i.e.: P C
RO OMM
Appendix B Note 1
The T
ERMINAL
ANSI T
Appendix B Note 2
Export/Import can be performed on either Port A or Port B. The Port must be
configured for ANSI T
If both Port A and Port B are ANSI T
by setting Port A device = None, or Switcher, or Tethered Remote,
and set Port B Device = ANSI.
Remember to P
rear panel) after changing any configuration parameters,
press C
installed on the C
are not sure. An unbuffered 8550 UART will lose data during E
which cannot be detected until a later I
Baud, always use S
HJT Model 100 User's Guide
3.1 OS. We will use the W
INDOWS
) but all testing has been done with the T
application setup is the same as for controlling the projector via an
(refer to HJT Model 100 Projector User's Guide, Chapter 3)
ERMINAL
ERMINAL
Port A speed is determined by Dip Switch #4 on the System Controller
board. O is 9600 baud, O
N
Port B can be configured for 2400, 9600 (default), or 19200 through the
C S M .
OMM ETUP ENU
O (C
OWER FF
+ S + ^ to reset.
ONTROL HIFT
WARNING!
Your computer must have a 16550 UART
P
OMM ORT TO
OFTWARE
INDOWS
ERMINAL
.
is 19200 Baud.
FF
, use Port A for Export/Import,
ERMINALS
+ P) and HW R
ONTROL
use 19200 Baud— use 9600 Baud if you
is attempted. With either
MPORT
F C (X /X
LOW ONTROL ON
T application
ERMINAL
application.
(circuit breaker—on
ESET
P O , then
OR OWER FF
,
XPORT
).
OFF
Appendix B-1