Table of Contents
Advertisement
6.0 System Specifications
NOTE: HJT Model 100 Projector specifications are subject to change without notice.
Image Quality
Brightness
Contrast Ratio
RGB Bandwidth
Aspect Ratio
Uniformity
Graphics Resolution
Video Resolution
Video Response Time
Color Coordinates
Input Compatibility
Horizontal Scan Frequency
Vertical Scan Frequency
Blanking
Source Compatibility
Parameter Storage
Decoder (optional)
Inputs
RGB Input Cards (VIC)
Signal Level
Sync Level
Decoder Video Input Card
(Optional)
Video Level
S-Video Y Level
C Level
Switching Time Between
Sources
Control Ports
Terminal
Tethered IR Remote
IR Remote
HJT Model 100 User's Guide
1500 ANSI Lumens.
200:1 Sequential. 150:1 ANSI.
120 Mhz (measured at -3 db point).
4:3 - 16:9 (variable).
1.5:1 center to edge - ANSI points.
3:1 center to corner.
2000 (H) x 1500 (V).
1500 TV line (4:3).
• 16.7 ms.
SMPTE 240M.
30-135 kHz.
50-150 Hzs.
• 2.3 µs (H) • 500 µs (V).
2730 (H) x 2048 (V).
99 Channels/20 Sources.
Optional PAL/SECAM/NTSC (3.58/4.43) with line doubler.
75 ohm BNC input for R,G,B,H,V.
.5-1.2V p-p /Offset: 3VDC(0.7V Nominal).
.3-4V p-p, Composite Sync(H), separate H&V, or Sync on
Green(G) / Offset: 3VDC.
75 ohm BNC inputs for Composite and Y/C.
1V p-p with Sync / Offset: 3 VDC.
1V p-p with Sync / Offset: 3 VDC.
300mV p-p / Offset: 3 VDC.
• 2 Sec.
2 full RS-232 inputs for ANSI Terminal, tethered remote, External
Video Switcher or Serial External Communications Protocol with
DATA spec up to 19.2k BAUD.
Input connection for remote control or IR Repeater.
Front and rear receivers.
6-1
Advertisement
Table of Contents
