Installing (Or Removing) A Vic - Hughes JVC CB100 User Manual

Chapter 4—Setup Adjustments
4.11.1.
R
Figure 4.0-19 Projector RGBHV Inputs with Optional Component
4-40

Installing (or Removing) a VIC

To install a VIC:
1. Turn projector power off with the remote.
2. Remove the two (2) screws and panel covering the optional VIC slot
(see Figure 4.0-19). Slide the VIC into the VIC slot to the right of the
standard RGBHV inputs. Retain the screws removed from the panel
to install the VIC.
NOTE: Two (2) panels must be removed to install a Quad RGBHV
Video Mux (multi-port) VIC or a Quad Standard Decoder Module
(with Line Doubler) VIC.
3. Tighten the two (2) screws (four [4] screws on the Quad RGBHV
Video Mux [multi-port] VIC or the Quad Standard Decoder [with
Line Doubler] VIC) on the left and right side of the VIC
(see Figure 4.0-19 ).
REMOTE
G B H/CS V
RGBHV Video Input
HDTV (YP P ) Input Module VIC Installed
b r
To remove a VIC:
1. Turn projector power off with the remote.
2. Disconnect all input connectors and label them, if necessary.
3. Loosen the two (2) holding screws on the left and right sides of the
VIC (Table 4.0-5 lists specific reference Figures for each VIC) screws
must be completely loose to remove the VIC.
4. Grasp the VIC connector bracket and pull the VIC out (wiggle the VIC
a little, if necessary, to extract it).
IR IN
Hughes-JVC Technology Corporation