Table of Contents
Advertisement
Chapter 3—Operation
Highlights show valid
sources for active channel
(CH 14).
Pointer shows active source
for the channel, provided
it is visible on screen.
Pointer is a tilde (~) if source
is an approximate match.
3.10. Picture Settings
3-16
MAIN
SOURCES
#
Name
1
PC
2
VGA
3
SVGA1
4
SVGA2
5
HD
6
PALLD
7
8514A
8
VIC 2.1
Figure 3.0-5 Active and Highlighted Sources
The Active Source is the source the active channel displays on the screen,
indicated by the lower left pointer under the S
source is also displayed on the S
5. The other highlighted sources displayed are additional valid sources for the
highlighted channel (CH 14).
NOTE: Procedures on setting up new sources begin with Section 4.1.on page 4-2.
To adjust picture settings:
1.
Select #1, P
ICTURE
2.
Press the number of the selection to be adjusted.
3.
Use the arrow keys to increase or decrease the settings for Brightness,
Contrast, Tint, Color, or Sharpness. Contrast can be adjusted by individual
color by toggling the RGB key to highlight the color desired and using the
up/down arrow keys to adjust. Tint, Color, and Sharpness are not active on
standard RGB VICs.
NOTE: Repeatedly pressing the RGB key toggles from RGB
(all colors on screen) to Red then Green then Blue then back to all colors.
4.
The B
E
LACK
NHANCE
image. After selecting the proper levels for the picture settings, select B
E
from the P
NHANCE
that provides the best black detail in the dark areas of the picture.
CH 14 (HDTV)
H (kHz)
V (Hz)
81.1
60
31.5
72.0
44.5
72.4
56.6
60.8
33.5
60.2
31.5
50.1
34.5
61.1
33.5+
60.2+
OURCES
list in the upper right corner of Figure 3.0-
OURCES
from the M
M
.
AIN
ENU
feature enhances black detail in the dark areas of the
menu. Use the arrow keys and select the level
ICTURE
Hughes-JVC Technology Corporation
Indicates channel
highlighted on the
I
C
HANNELS
I
Also shows source in
brackets if this highlighted
channel is also active
(on screen)
If the highlighted channel
indicated here is not the
I
active channel,
the source is blank.
I
I
This column shows if
the scan is interlaced
or not ( I = interlaced,
blank = non-interlaced).
I
in Figure 3.0-5. The active
list (CH 14).
LACK
Advertisement
Table of Contents
