Table of Contents
Advertisement
ux-22oocMuIcMc
FO-215ocMuKMc
3. Connections
0
Handset
Connect the handset as shown and place it on the handset rest.
+ The ends of the handset cord are identical, so they will go into
either jack.
Make
sure the
handset cord goes
into
the
unmarked
jack on the side of
the machine!
make
ordinary phone
Q
Power cord
Plug the power cord into a 120 V, SO Hz, grounded (3-prong)
AC outlet.
Caution!
Do not plug the power cord into any other kind of outlet.
This will damage the machine and is not covered under the
warranty.
@ Telephone line cord
Insert one end of the line cord into the jack on the back of the
machine marked
TEL. LINE. Insert the other end into
a standard (RJllC)
single-line wall telephone jack.
Note:The Sharp MFP is set for touch-tone
dialing. If you are
on a pulse dial (rotary) line, you must set the Sharp MFP for
pulse dialing. Press the following keys on the operation panel:
=-G9
0
until
-Press
#
display
DIAL MODE
-
shows:
TONE
PULSE
@or@
I
-
TAD CONNECTED
Note:lf your area experiences
a high incidence of lightning
or power surges, we recommend
that you install surge
protectors for the power and telephone
lines.
Surge protectors can be purchased
at most telephone
specialty stores.
l-5
Advertisement
Table of Contents
