Lp Conversion Instructions - Quadra-Fire QFP 30 Operation & Maintenance Manual

Direct vent gas fireplace

Hide thumbs

Table Of Contents

Table of Contents

Manufacturer's conversion kit supplied with the fireplace is required for this procedure.

NOTE: If converting this unit to propane, so do at this point of installation.

THE INSTALLATION OF THIS CONVERSION KIT MUST ONLY BE UNDER-

TAKEN BY A QUALIFIED AND CERTIFIED GAS APPLIANCE INSTALLER.

This conversion kit shall be installed by a qualified service agency in accordance

with the manufacturer's instructions and all applicable codes and requirements of the

authority having jurisdiction. If the information in these instructions is not followed

exactly, a fire, explosion or production of carbon monoxide may result causing property

damage, personal injury or loss of life. The qualified service agency is responsible

for the proper installatin of this kit. The installation is not proper and complete until

the operation of the converted appliance is checked as specified in the manufacturer's

CAUTION! DISCONNECT ANY ELECTRICAL CORDS AND

TURN OFF GAS SUPPLY TO UNIT BEFORE PROCEED-

ING.

Valve Regulator Tower

Turn control knob to the OFF position and shut off the

gas supply to the valve.

Using a Torx TH20, or slotted screwdriver, remove the

three pressure regulator mounting screws (A), pressure

regulator tower (B), and diaphragm (C). (You may wish

to retain these items for converting back to original gas

if necessary.)

Insure that the rubber gasket (D) is properly positioned

and install the new HI/LO pressure regulator assembly to

the valve using the new screws (E) supplied with the kit.

Tighten screws securely. (Reference torque = 25in/lb)

Install the enclosed identification label (F) to the valve

body where it can be seen.

Continued on next page.

03/21/01 #250-6120

QFP 30 Direct Vent Gas Fireplace