Quadra-Fire QFP 30 Operation & Maintenance Manual page 12

1. Remove glass frame by unlatching door in each corner.
Fig. 1.
2. If installed, remove logs, embers, and lava rock. retain
these items.
3. Remove burner tray with Phillips screwdriver. There are
(7) screws in tray, (3) in front and (2) on each side. Lift
tray up and out. Fig. 2 & 3.
4. With Phillips screwdriver, remove (2) screws on burner
pan. Remove pan by lifting up on right hand side of
burner and pulling to the right. Take care not to bend
air shutter rod. Fig. 4.
5. Use a 5/8" wrench to remove burner orifice and replace
with correct orifice for LP. Fig. 5.
6. Remove pilot hood by pulling up on hood. Fig. 6. Then
use a 5/32" Allen wrench to remove pilot orifice and
replace with orifice supplied in kit. Fig. 7.
7. Replace all parts in reverse order.
Page 12
QFP 30 Direct Vent Gas Fireplace
LP CONVERSION, CONT.
FIG. 1
PULL TO
RELEASE -
2 ON TOP & 2
ON BOTTOM OF
DOOR/GLASS
FIG. 2
FIG. 3
FIG. 4
FIG. 5
FIG. 6
FIG. 7
03/21/01 #250-6120