Trouble Codes; A. Trouble Codes List - Sharp AR-203E Service Manual

Main Sub
Contents
code code
66 38 Time setting/check
(Executable only when the
FAX is installed.)
67 50 USB receive speed
adjustment (USB1.1)
(AR-203E only)

5. Trouble codes

A. Trouble codes list

Main Sub
code code
E1 00 IMC communication trouble
10 IMC trouble
13 IMC flash ROM error
81 IMC communication interface error (Parity)
82 IMC communication interface error (Overrun)
84 IMC communication interface error (Framing)
E7 01 Duplex model memory setup error, memory not-
detected error
02 LSU trouble
10 Shading trouble (Black correction)
11 Shading trouble (White correction)
[Function]
Use to check the time setting.
[Operation]
1) Initial display
SELECT TO SET
1:DATE
∗ [Clear] key: FAX control is terminated.
2) Select 1
xxxx.xx.xx(xxx)
CHANGE? 1:YES 2:NO
"xxxx.xx.xx(xxx)" is the current value. (No
revision of display)
3) Select 1
INPUT YEAR
(4 DIGITS)____.__.__
∗ Select 2: Returns to "1) Initial display".
4) Enter the year in 4 digits.
INPUT MONTH
(1-12) 1998.__.__
5) Enter the month in 2 digits.
INPUT DAY
(1-31) 1998.01.__
6) Enter the day in 2 digits.
xxxx.xx.xx(xxx)
STORED? 1:YES 2:NO
"xxxx.xx.xx(xxx) is the entered value.
∗ Select 2: Returns to "1) Initial display".
7) Select 1
STORED
After 2sec, returns to "1) Initial display".
Used to set the limitation on the print data receive speed of USB2.0 (Full speed) port (USB port
on the machine).
→ When print images from USB2.0 (Full speed) port are disturbed, change the setting and try
again.
When this simulation is executed, the currently set code number is displayed.
Enter the code number corresponding to the adjustment value, and press [START] key to
change the setting.
Code number
1
2
3
4
Details of trouble
AR-203E/5420/M200/M201 SIMULATION, TROUBLE CODES 10 - 40
Details of function/operation
2:TIME
Setting
FAST
NORMAL1
NORMAL2
SLOW
Main Sub
code code
E7 16 Abnormal laser output
F2 02 Toner supply abnormality
04 Improper cartridge (Destination error, life cycle error)
F5 02 Copy lamp lighting abnormality
F6 10 FAX board trouble
H2 00 Thermistor open
H3 00 Heat roller high temperature detection
H4 00 Heat roller low temperature detection
L1 00 Feeding is not completed within the specified time
after starting feeding. (The scan head locking switch
is locked)
2) Select 2
xx:xx
CHANGE? 1:YES 2:NO
"xx:xx" is the current value.
3) Select 1
INPUT HOUR
(0-24) __:__
∗ Select 2: Returns to "1) Initial display".
4) Enter o'clock in 2 digits.
INPUT MINUTE
(00-59) 01:__
5) Enter minute in 2 digits.
xx:xx
STORED? 1:YES 2:NO
"xx:xx" is the current value.
∗ Select 2: Returns to "1) Initial display".
6) Select 1
STORED
After 2sec, returns to "1) Initial display".
Speed
↑ Fast
↓ Slow
Details of trouble