Sharp AR-203E Service Manual page 87

Main Sub
Contents
code code
26 04 Machine duplex setup
06 Destination setup
07 Machine conditions check
20 Rear edge void setup
30 CE mark support control
ON/OFF
37 Cancel of stop at developer
life over
39 Memory capacity check
[Function]
When this simulation is executed, the current set duplex is displayed. Enter the code number
corresponding to the desired duplex and press [OK]/[ENTER]/[START] key to save the setting.
Code number
0 Duplex NO
1 Duplex YES*
* AR-203E/5420/M200: cannot be executed.
[Operation]
The operation is similar to simulation 26-02.
[Function]
When this simulation is executed, the current set destination is displayed. Enter the code num-
ber corresponding to the desired destination and press [OK]/[ENTER]/[START] key to save the
setting.
Code number
0 Inch series
1 EX Japan AB series
2 Japan AB series
* Code number 2 cannot be selected.
[Operation]
The operation is similar to simulation 26-02.
[Function]
When this simulation is executed, the current machine setting is displayed.
CPM
20 CPM
[Operation] (AR-M200/M201)
1) The machine setting is displayed.
26-07 CPM
20 CPM
[Function]
When this simulation is executed, the current set rear edge void is displayed. Enter the code
number corresponding to the desired rear edge void and press [OK]/[ENTER]/[START] key to
save the setting.
Code number
0 Rear edge void NO
1 Rear edge void YES
[Operation]
The operation is similar to simulation 26-02.
[Function]
When this simulation is executed, the current set CE mark support control is displayed. Enter
the code number corresponding to the desired CE mark support control and press [OK]/
[ENTER]/[START] key to save the setting.
Code number
0 CE mark support control OFF
1 CE mark support control ON
[Operation]
The operation is similar to simulation 26-02.
[Function]
When this simulation is executed, the current setting is displayed. Enter the code number and
press [OK]/[ENTER]/[START] key to change the setting.
[Operation]
The operation is similar to simulation 21-01.
[Function]
When the simulation is executed, the currently installed SDRAM of the main unit is displayed.
Code number
8
16
[Operation] (AR-M200/M201)
1) Memory capacity display
26-39 MEM.CHK
8 MBYTE
AR-203E/5420/M200/M201 SIMULATION, TROUBLE CODES 10 - 14
Details of function/operation
Duplex Display item
OFF
ON
Destination
Copy quantity Remark
20
Setting
Setting
Setting Remark
8 MBYTE
16 MBYTE
Display item
INCH
AB
–
Display item Remark
OFF
ON Default
Display item Remark
OFF Default (100V series)
ON