B. Print Mode - Sharp AR-203E Service Manual

Program
Program name
number
19 AE LEVEL ADJUST
20 LANGUAGE
21 RESET FACTORY
22 SORT AUTO
SELECT
24 CHECK RSPF
OPEN
25 VALID COPY
WIDTH
28 LSU SETTING
29 PAPER TYPE
30 DISPLAY
CONTRAST

B. Print mode

Program
Program name
number
1 FORCED OUTPUT
2 USB 2.0 MODE
1
SWITCH *
3 AUTO TRAY
2
SWITCH*
1
* : The scanning speed increases when the USB 2.0 mode is set to "HI-SPEED", however, the printing speed does not increase considerably.
2
* : When the 250-sheet paper feed unit is installed.
Setting codes
(factory default setting
appears in bold)
1: SPF/RSPF • This is used to adjust the exposure level.
(Adjustment to 5 levels • The automatic exposure level can be adjusted separately for the document
is possible.)
2: DOCUMENT GLASS • For the procedure for adjusting the exposure and guidelines for numeric
(Adjustment to 5 levels
is possible.)
1: AMERICAN ENGLISH • This is used to set the language used in the display.
2: ENGLISH
3: FRENCH
4: SPANISH
:
:
1: Yes • This is used to return all settings to the factory default settings.
2: No
1: ON • Use this setting to enable or disable sort auto select mode.
2: OFF
1: ON • You can set the operation that takes place if the [START] key (
2: OFF
1: 8.5x11 • Set the allowed paper sizes for copying from the bypass tray. When
2: 5.5x8.5
1: ON • Select whether copying is only allowed when the polygon motor is rotating,
2: OFF
1: PLAIN PAPER • Set the temperature of the fusing unit when the bypass tray is used.
2: HEAVY PAPER
1: LIGHTER • Set the contrast of the display.
2: LIGHT
3: NORMAL
4: DARK
5: DARKER
Setting codes
(factory default setting
appears in bold)
1: ON • When this function is enabled, printing in printer mode will automatically
2: OFF
1: FULL-SPEED • This sets the USB 2.0 data transfer speed. To obtain the fastest speed when
2: HI-SPEED
1: ON • If the paper runs out during printing and there is paper of the same size in
2: OFF
AR-203E/5420/M200/M201 USER PROGRAM 12 - 4
glass and the RSPF.
values. The factory default setting for the exposure level is center.
pressed when the RSPF is not completely closed. (Valid only when the
multi-bypass paper feed is used.)
"5.5x8.5" is selected, a copy of a letter size original will only be printed up
to invoice size.
or also when the polygon motor is stopped.
Normally "HEAVY PAPER" should be selected.
continue using a different size of paper if the specified size of paper runs out
in all trays. This feature does not function in copy mode.
using the USB 2.0 connector, first verify that your computer meets the
system requirements (operating system and driver), and then use this
program to change the USB 2.0 mode to "Hi-Speed". Note that the setting
should not be changed while running a TWAIN driver.
another tray, this function automatically switches to that tray (excluding the
bypass tray). The function can be disabled.
Explanation
Explanation
) is