Sharp AR-203E Service Manual page 50

2) Remove two screws, and remove the earth wire.
3) Disconnect the connector.
4) Remove the original cover.
5) Remove five screws. Remove the operation unit, and discon-
nect the connector.
6) Remove the right cabinet.
7) Remove the left cabinet.
8) Remove the screw, and remove the rear cover.
9) Remove the table glass.
1)
5)
2)
1)
1)
7)
8)
1)
3)
AR-203E/5420/M200/M201 DISASSEMBLY AND ASSEMBLY 8 - 6
10) Move the carriage to the position indicated on the figure.
11) Loosen the screw which is fixing the tension plate.
12) Move the tension plate in the arrow direction to release the
tension, and remove the belt.
3)
2)
13) Remove the screw, and remove the rod stopper.
14) Remove the rod.
1)
15) Lift the rear side of the carriage, remove the belt and the con-
nector, and remove the carriage.
4)
2)
4)
1)
3)
2)
1)
1)
4)
3)