Table of Contents
Advertisement
3
RECORDING
POWER indicator
Normal recording
Use the following procedure to record the monitored video
in the normal recording area.
Recording will not be possible until a time has been set for
the digital video recorder. Make sure to set the time.
( P.17)
1
Press the [REC/STOP] button.
The REC/STOP indicator lights up, "REC" appears on-
screen (i.e., the recording symbol), and recording starts.
REC/STOP
When recording for the first time, the default settings
are used. For details regarding modification of the
picture quality or recording rate, see P.71.
When the space remaining in the normal recording area
drops below a preset value, the FULL indicator on the
digital video recorder's front panel starts to flash. If
recording is continued beyond this point, the normal
recording area will become full, recording will stop, and
the FULL indicator will stop flashing and remain lit. In
such a case, use the <RECORDING AREA SET>
screen to perform "AREA FULL RESET" for the normal
recording area, thus allowing recording to start again
from the beginning. ( P.67)
Playback is possible even while recording. See P.26 for
more details.
Ending normal recording
2
Press and hold the [REC/STOP] button
for approximately 3 seconds.
"REC" disappears from the operation display and
recording ends.
REC/STOP
English
FULL indicator
[REC/STOP] button
Recording symbol
0
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
02
[TIMER] button
Timer recording
Use the following procedure to record the monitored video
for a preset length of time in the normal recording area.
Recording will not be possible until a time has been set for
the digital video recorder. Make sure to set the time. ( P.17)
1
Press the [TIMER] button.
The TIMER indicator lights up and the digital video
recorder enters timer recording standby mode.
TIMER
(1) See P.74 for more details on timer recording settings.
(2) At the time specified for the start of timer recording, the
REC/STOP indicator lights up, "REC" appears on-
screen (i.e., the recording symbol), and recording starts.
(3) At the time specified for the end of timer recording, the
REC/STOP indicator turns off, and recording ends.
The [TIMER] button remains lit up.
When the space remaining in the normal recording area
drops below a preset value, the FULL indicator on the
digital video recorder's front panel starts to flash. If
recording is continued beyond this point, the normal
recording area will become full, recording will stop, and
the FULL indicator will stop flashing and remain lit. In
such a case, use the <RECORDING AREA SET> menu
to perform "AREA FULL RESET" for the normal
recording area, thus allowing recording to start again
from the beginning. ( P.67)
Playback is possible even while recording. See P.26 for
more details.
Stopping timer recording before completion
2
Press the [TIMER] button.
The TIMER indicator turns off and recording ends.
TIMER
23
CARD
CARD
MENU
RESET
EJECT
0
01-01-04 00:00:00 REC REPEAT EN A ALARM 0000
02
Advertisement
Table of Contents
