Sanyo DSR-3716P Instruction Manual page 60

2 INITIAL SET
9
In the same manner as described set
the hours and minutes of T-1, T-2, T-3,
and T-4 for "TIME PERIOD B" settings.
For both TIME PERIOD A and TIME PERIOD B, all
settings are "00:00" by default.
Settings for T-1 through T-4 cannot be made in such a
way that they extend over two days (i.e., include
midnight).
Example: T-1
06:00
In the above example, setting is not possible between
T-3 and T-4 due to the change in the date.
Any setting of "00:00" for T-2 through T-4 will be
skipped. If "00:00" (midnight) must be set, this should
be done using T-1.
Example: T-1
06:00
In the above example, T-4 (00:00) is skipped and T-3
operates between 18:00 and 06:00.
Furthermore, when T-1 through T-4 are all set to
"00:00", all but T-1 are ignored, and T-1 operates from
midnight to midnight.
Time period operations settings
Example 2: Setting time period operation as follows.
Automatic selection and monitor masking for "TIME
PERIOD A".
Motion sensing for "TIME PERIOD B".
English
<TIMER PERIOD SET>
TIME PERIOD T-1 T-2 T-3 T-4
TIME PERIOD A 06:00 11:30 13:30 18:00
TIME PERIOD B 06:00 08:00 14:30 20:00
SELECT TIME PERIOD
SEQUENCE TIME PERIOD A
MASK TIME PERIOD A
MOTION SENSOR TIME PERIOD A
T-2 T-3 T-4
12:00 18:00 02:00
T-2 T-3 T-4
12:00 18:00 00:00
<TIMER PERIOD SET>
TIME PERIOD T-1 T-2 T-3 T-4
TIME PERIOD A 06:00 11:30 13:30 18:00
TIME PERIOD B 06:00 08:00 14:30 20:00
SELECT TIME PERIOD
SEQUENCE TIME PERIOD A
MASK TIME PERIOD A
MOTION SENSOR TIME PERIOD A
1
Turn the jog dial to move the cursor to
"SEQUENCE" within "SELECT TIME
PERIOD", and then turn the shuttle dial
clockwise.
"TIME PERIOD A" flashes.
2
Turn the jog dial to select "TIME
PERIOD A", and then turn the shuttle
dial clockwise.
The cursor moves to "MASK".
3
Set the time period for "MASK" and
"MOTION SENSOR" in the same way.
4
Press the [EXIT/OSD] button.
The setting procedure is ended and the display returns to
the normal screen.
Automatic selection, masking, and motion sensors are all
set to "TIME PERIOD A" by default.
EXIT/OSD
As a result of the above operations, "SEQUENCE" are
updated using main monitor and monitor 2 settings on
; "MASK" are updated using mask settings from on
P.102
; and "MOTION SENSOR" are updated using
P.104
motion sensor settings on
59
<TIMER PERIOD SET>
TIME PERIOD T-1 T-2 T-3 T-4
TIME PERIOD A 06:00 11:30 13:30 18:00
TIME PERIOD B 06:00 08:00 14:30 20:00
SELECT TIME PERIOD
SEQUENCE TIME PERIOD A
MASK TIME PERIOD A
MOTION SENSOR TIME PERIOD A
.
P.81