SMART Board 800ixe-MP Configuration And User's Manual page 5

I M P O R T A N T I N F O R M A T I O N
Cycling power to the projector repeatedly can lock or damage your SMART product. After
l
you put the product into Standby mode, wait at least 45 minutes for cooling before starting
the product again.
Do not adjust any settings in the service menu other than those listed in the following
l
procedures. Changing other settings might damage or affect the operation of your projector
and may invalidate your warranty.
Before you clean the SMART UX60 projector, press the Power
l
select the Standby button or press the Power
projector into Standby mode.
Do not spray cleaners, solvents or compressed air near any part of the projector because
l
they can damage or stain the unit. Spraying the system could spread a chemical mist on
some of the projector's components and lamp, resulting in damage and poor image quality.
Do not allow liquids or commercial solvents of any kind to flow into the projector.
l
When transporting your SMART product, repack it with as much of the original packaging as
l
possible. This packaging was designed with optimal shock and vibration protection.
If your SMART product requires replacement parts, make sure the service technician uses
l
replacement parts specified by SMART Technologies or parts with the same characteristics
as the original.
iii
button on the ACP and
button twice on the remote control to put the