Table of Contents
Advertisement
Operation
Compel™
The Unity 552 IRD is most often controlled via the WEGENER Compel Control System . This
System
system is managed at the uplink site, sending a control stream with the usual audio and
video data streams. The Compel System addresses units, and commands them to perform
Control
various functions.
Among its functions is the ability to enable or limit aspects of local control. Also, Compel has
the ability to mute the audio and video of an IRD if it is inadvertently tuned to a frequency it
is not authorized to receive.
If an RF Switch option module is installed, Compel controls which of the four RF feeds is
being processed. For more information on this, see the Compel Manual, or contact your
service provider.
There are four levels of control via Compel . These levels are:
No Local Control - Push-buttons disabled
Read Only - No changes permitted
Limited - Changes may be made to Carrier Presets (pre-loaded values) only
Full - Full Local Control
3.2 Normal Functions
The Unity 552 allows several functions for basic operation and optimum performance.
Tune to a carrier
Configure LNB options
Monitor Signal Quality
Set Subtitling
Configure operating options:
Monitor status information:
Each of these functions is illustrated below with instructions, OSD screens and other
relevant information.
16
Set Decoder options
Setup Audio
Set LAN IP Networking options
Set Terminal options
Set User Relay
Set Date and Time information
Set Unit Label
Switch Application (to different software version)
View Signal Quality
Query Networking History
Display LAN IP Network information
Find Software Version information
Clear Statistics used for diagnosis
800089-01 Rev. C
www.wegener.com
Advertisement
Table of Contents
