Table of Contents
Advertisement
Operation
4. When the six-character label is selected, use the up/down and left/right buttons to set
Switch Application (to different software version)
Use following steps to display Application Switch screen on the OSD menu:
1. Navigate to the Unit Setup screen, see Unit Setup screen
2. Press the down arrow button to select Switch Application .
3. View the details as shown in Figure 3.20 .
4. Use the Application Switch to run a backup version of the software on the unit. Upon
Monitor
The following types of status information are available for viewing:
Status
Signal Quality
Information
Current Quality
History This Setting
Elapsed Times
Unit Status screen
Use following steps to display the Unit Status screen on the OSD menu:
1. Press any push-button on the front-panel to display the Main Menu .
2. Press the down arrow button to select Advanced Setup .
3. Press Enter .
4. Press the down arrow button to select Unit Status .
5. Press Enter .
30
to a desired label. Press Enter to save the change. Use the left arrow button to go to
the previous menu level.
selecting the Backup Software by pressing Enter , the system restarts with the
different software which is labeled as current. The previously run software is labeled
backup. Use the Version Information screen to find out about the software versions
installed in the system.
Figure 3.20: Unity 552 OSD Application Switch
800089-01 Rev. C
on page
23.
www.wegener.com
Advertisement
Table of Contents
