Table of Contents
Advertisement
Quick Links
Data, drawings, and other material
contained herein are proprietary to
Wegener Communications, Inc., and
may not be reproduced or duplicated in
any form without the prior permission of
Wegener Communications, Inc.
When ordering parts from Wegener
Communications, Inc., be sure to include
the equipment model number, equipment
serial number, and a description of the part.
In all correspondence with Wegener
Communications, Inc., regarding this
publication, please refer to 1999-001.
Preliminary Edition: April, 1999
PRELIMINARY April 15, 1999
Instruction Manual
Model 1999
2
®
FM
Addressable Satellite
Audio Receiver
WEGENER
COMMUNICATIONS
TECHNOLOGY PARK / JOHNS CREEK
11350 TECHNOLOGY CIRCLE
DULUTH, GEORGIA 30097-1502
(770) 814-4000 FAX (770) 623-0698
R
Advertisement
Table of Contents
Related Manuals for Wegener muzak FM2 1999
Summary of Contents for Wegener muzak FM2 1999
- Page 1 Wegener Communications, Inc. When ordering parts from Wegener Communications, Inc., be sure to include the equipment model number, equipment serial number, and a description of the part.
- Page 2 The following warranty applies to all Wegener Communications products. All Wegener Communications products are warranted against defective materials and workmanship for a period of one year after shipment to customer. Wegener Communications' obligation under this warranty is limited to repairing or, at Wegener Communications' option, replacing parts, subassemblies, or entire assemblies.
-
Page 3: Table Of Contents
Table of Contents SECTION 1 - GENERAL INFORMATION Paragraph Title Page 1.1 INTRODUCTION ................... 4 1.2 PURPOSE OF EQUIPMENT ..............4 SECTION 2 - INSTALLATION 2.1 GENERAL ..................... 5 2.2 UNPACKING AND INSPECTION ............5 2.3 MECHANICAL ..................6 2.4 ELECTRICAL ..................6 2.4.1 Rear Panel Interconnect ............... -
Page 4: Section 1 - General Information
SECTION 1 GENERAL INFORMATION INTRODUCTION This manual describes the installation and operation of the Wegener Communications Model 1999 ® Addressable Satellite Audio Receiver. PURPOSE OF EQUIPMENT Satellite audio receivers (figure 1-1) provide high quality audio services from a satellite earth station. -
Page 5: Section 2 - Installation
SECTION 2 INSTALLATION GENERAL This section contains information required to unpack and install a Model 1999 ® Addressable Satellite Audio Receiver. UNPACKING AND INSPECTION Carefully unpack the unit and inspect it for obvious signs of physical damage, which might have occurred during shipment. -
Page 6: Mechanical
MECHANICAL The Model 1999 receiver is 8 inches wide, 12 inches deep and 3 inches high. Rubber feet on the bottom plate allow the receiver to be set on a tabletop or other flat surface. It is recommended that the unit will be installed within 5 feet of an AC outlet, and where adequate ventilation is provided. -
Page 7: Model 1999 Fm Addressable Satellite Audio Receiver, Front Panel
Connect the audio outputs using the unbalanced output. The unbalanced audio monitor must be connected to HIGH impedance inputs only. The Serial Port (RJ-12) is designed to interface directly to Diamond DX messaging unit or other three wire serial DTE devices. The power supply for the unit consists of an external transformer that supplies the correct AC voltages to the unit, and the necessary circuitry to produce all necessary DC voltages. -
Page 8: Model 1999 Fm 2 Addressable Satellite Audio Receiver, Front Panel
TABLE 2-1. MODEL 1999 ® ADDRESSABLE SATELLITE AUDIO RECEIVER, REAR PANEL Signal Description RF Input 950 MHz to 2050 MHz from LNB and DC power to LNB. Audio Unbalanced Audio Output, High Impedance. Serial Port RS-232 DCE Output via an RJ-12 Connector Pin 1 –... -
Page 9: Section 3 - Operation
SECTION 3 OPERATION GENERAL This section provides operating instructions that apply to the Model 1999 ® Addressable Satellite Audio Receiver. CONTROLS AND INDICATORS Table 3-1 describes the controls and indicator functions. TURN-ON PROCEDURE Connect the AC power supply cord to a suitable 117 volts AC, 60 Hz outlet. Connect the AC-to- AC adapter to the POWER connector on the rear of the receiver. -
Page 10: Model 1999 Fm 2 Addressable Satellite Audio Receiver, Rear Panel
signal can be measured through the rear panel OUTPUT connector to set the control for a precise level. TABLE 3-1. MODEL 1999 ® ADDRESSABLE SATELLITE AUDIO RECEIVER, CONTROLS AND INDICATORS Receiver Card Controls / Indicators Description STATUS Extinguished – When unit is not powered up or is not operational. - Page 11 Receiver Card Controls / Indicators Description Rear Panel Controls AUDIO LEVEL – Output level control for rear panel RCA connector. SQL. DEF. – Squelch Defeat for initial antenna installation. *FLASHING = ON for 1 sec, OFF for 1 sec, continuing. **FLICKERING = ON for 20 mS, OFF for 20 mS, continuing.
-
Page 12: Section 4 - Troubleshooting
SECTION 4 TROUBLESHOOTING, SPECIFICATIONS AND SERVICE TROUBLESHOOTING Table 4-1 lists troubleshooting procedures to be used with the Model 1999 ® Addressable Satellite Audio Receiver. TABLE 4-1. TROUBLESHOOTING Problem Corrective Action No module operation, status indicator is 1. Check power on AC outlet. extinguished. -
Page 13: Specifications
15V minimum with 170 mA maximum current (short circuit protected; ripple never drops below 15V) Power Requirements External Transformer Input Voltage 105 to 130 VRMS Frequency 47 to 63 Hz Consumption 22 watts PANDA is a registered trademark of Wegener Communications, Inc. 1999-001... -
Page 14: Service
SERVICE If the receiver fails to function as described, and the fault is not the interconnecting cables or otherwise obvious, then call the Muzak Network Operations Center at 1-800-327-6549 for assistance. 1999-001... - Page 15 1999-001...
- Page 16 1999-001...