Configure Lnb Options; Lnb Setup Screen; Table 3.3: Channel Information Options; Figure 3.5: Unity 552 Osd Current Channel Screen - Wegener Unity 552 User Manual

Operation
Use the Current Channel screen to set or display the channel information.
Option
Preset
Modulation
FEC Ratio
Frequency
Data Rate
Symbol Rate
Program
Tag Site
Configure

LNB Setup screen

LNB options
Use following steps to display LNB Setup screen on the OSD menu:
1. Press any push-button on the front-panel to display the Main Menu .
2. Press the down arrow button to select Carrier Settings .
3. Press Enter .
4. Press the down arrow button to select LNB Setup .
5. Press Enter . Figure 3.6 details the LNB Setup screen.
6. To navigate the screen, use down arrow and Enter to select an option. When the
18

Figure 3.5: Unity 552 OSD Current Channel Screen

Table 3.3: Channel Information Options

Possible values
Perm, Command, Last
Success or Current
QPSK/S2QPSK/S28PSK
1/2, 2/3, ¾, 5/6, 7/8
corresponding value of that option on the left is selected, use up or down buttons to
set to the desired setting. Press Enter when done. Move to the next option using up
or down button or left arrow to exit to the previous menu level.
800089-01 Rev. C
Comments
Only Perm option allows other options to be set.
The channel set using the Compel
-
-
Automatically calculated and displayed only
Set to the desired program # in the carrier
The tag #15 is a special value
Command.
www.wegener.com