Diagterm Terminal (Commands); Table 3.2: Unity 552 Front Panel Status Led Alarm And Warning Indications; Figure 3.3: Diagterm Terminal Help Screen - Wegener Unity 552 User Manual

indicate that, although output is being produced, there is a problem that could require
attention. The most common conditions that produce alarms or warnings are listed in Table
.
3.2

Table 3.2: Unity 552 Front Panel Status LED Alarm and Warning Indications

Diagterm
The Serial Port (RS-232) can be used to connect to a terminal console. After the IRD is
Terminal powered on, a diagterm command-line interface (CLI) can be used to monitor and control
the system. For more information on diagterm and syntax of the individual commands,
(Commands)
please see an appendix. Figure 3.3 illustrates the Help screen on the diagterm terminal.
www.wegener.com
Mode LED Status
Red blink = 2
Red blink = 3
Alarm Red blink = 4
Red blink = 5
Red blink = 11
Amber blink = 1
Amber blink = 2
Amber blink = 4
Warning
Amber blink = 5
Amber blink = 6
Amber blink = 7
Normal Green

Figure 3.3: Diagterm Terminal Help Screen

800089-01 Rev. C
Unity 552 User's Manual
Condition
No carrier
No RF signal
In recovery
Eb/No alarm
Not authorized
No response from SEC_MICRO
Marginal Eb/No
Selected audio not available
RF too low
RF too high
Application download failed
Normal operation
15