Table of Contents
Advertisement
Operation
Set LAN-based Decode options
Use following steps to display Decoder Source screen on the OSD menu:
1. Navigate to the Decoder Setup screen
2. Press the up or down arrow buttons to select Decoder Source .
3. Press Enter .
4. Press the up or down arrow buttons to select either LAN-Multicast or LAN-Unicast .
5. Press Enter .
6. Select Activate Settings .
7. Press Enter .
Use the Decoder Source screen to set and display the LAN Decode options.
Set LAN IP Networking options
Use following steps to display LAN IP Setup screen on the OSD menu:
1. Navigate to the Unit Setup screen, see Unit Setup screen
2. Press the down arrow button to select LAN IP Setup .
3. View the details as shown in Figure 3.16 .
26
Figure 3.15: Unity 552 OSD Decoder Source
Table 3.9: LAN Decode Options
Option
IP-Address
Multicast or Unicast IP Address
IP-Port Number
The corresponding IP Port number
Audio Routing
Stereo or Left/Right on both
Audio Attenuation
0 through 20
S/PDIF Mode
Passthru, Linear PCM or Off
800089-01 Rev. C
Possible values
on page
23.
www.wegener.com
Advertisement
Table of Contents
