Dynamic Braking Solenoid - Club Car 1998 Maintenance And Service Manual Supplement

12
ELECTRICAL COMPONENTS
Main Solenoid Removal
1. Place Tow/Run switch in the TOW position and disconnect batteries. See Figure 12-1, Page 12-2.
2. Remove the rear body access door.
3. Disconnect all wires from the solenoid (12) (Figure 12-4, Page 12-5).
4. Loosen, but do not remove, one of the thread rolling screws (11) that hold the solenoid mounting bracket (10)
to the component mounting plate (Figure 12-4, Page 12-5).
5. Lift the solenoid (12) up and out of the mounting bracket (10) (Figure 12-4, Page 12-5).
Main Solenoid Installation
1. Mount solenoid (12) onto component mounting plate with mounting bracket (10) (Figure 12-4, Page 12-5).
2. Tighten thread rolling screws (11) to 20 in.lb (2.2 N-m) (Figure 12-4, Page 12-5).
3. Install washers (8), wires (2, 4 and 13) and lock nuts (1) onto large mounting posts. Tighten nuts to 60 in.lb (6.7 N-m)
(Figure 12-4, Page 12-5). See Section 11, Figure 11-1, Page 11-2 for wire destinations.
4. Install wires (3 and 6) and nuts (7) onto small mounting posts. Tighten to 18 in.lb (2.0 N-m) (Figure 12-4, Page
12-5).
5. Install rear body access door.
6. Connect batteries (positive cable first) (Figure 12-1, Page 12-2) and tighten to 110 in.lb (12.4 N-m). Place
Tow/Run switch in RUN.
13
8
16
12

DYNAMIC BRAKING SOLENOID

Read DANGER and WARNING on page 12-1.
The dynamic braking solenoid is located on the driver side of the electrical component mounting plate.
Page 12-6 1998/1999 PowerDrive Plus Maintenance and Service Supplement
1
2
5
6
7
15
TYPICAL
11
2 PLACES
Figure 12-5 Dynamic Braking Solenoid
14
3
4
9
4
5
6
10
Dynamic Braking Solenoid