Reverse Buzzer; Main Solenoid - Club Car 1998 Maintenance And Service Manual Supplement

ELECTRICAL COMPONENTS

REVERSE BUZZER

Read DANGER and WARNING on page 12-1.
Testing the Reverse Buzzer
See Test Procedure 17, Section 11, Page 11-21.
Reverse Buzzer Removal
1. Place Tow/Run switch in the TOW position, disconnect batteries (Figure 12-1, Page 12-2) and discharge speed con-
troller.
2. Remove center dash. See Remove Center Dash, page 12-2.
3. Disconnect the 18 gauge red and orange wires from reverse buzzer.
4. Remove the two screws from the reverse buzzer. Remove the reverse buzzer from the center dash panel.
Reverse Buzzer Installation
1. Install the reverse buzzer in the reverse order of removal. Tighten screws to 4 in.lb (0.45 N-m).
2. Reconnect battery wires (positive cable first) and tighten to 110 in.lb (12.4 N-m). Place Tow/Run switch in the
RUN position.

MAIN SOLENOID

Read DANGER and WARNING on page 12-1.
The main solenoid is located on the passenger side of the electrical component mounting plate.
Testing the Main Solenoid
See Test Procedure 3, Section 11, Page 11-15.
1
3
2
4
8
12
Figure 12-4 Main Solenoid
13
5
8
7
TYPICAL
2 PLACES
6
10
11
TYPICAL
2 PLACES
1998/1999 PowerDrive Plus Vehicle Maintenance and Service Supplement Page 12-5
12
Reverse Buzzer