Club Car 1998 Maintenance And Service Manual Supplement page 112

15
MOTOR
Motor Speed Sensor Removal
1. Place Tow/Run switch in the TOW position and disconnect battery cables (Figure 15-1, Page 15-2).
2. Disconnect the three-pin connector (22) (Figure 15-18, Page 15-14).
3. Remove the three retaining screws (24) from the retaining plate (23) located on the motor end shield (10)
(Figure 15-18, Page 15-14).
4. Remove motor speed sensor (21) from recessed area on motor (Figure 15-18, Page 15-14).
Motor Speed Sensor Installation
1. Position the motor speed sensor (21) in the recessed area on the motor. Sensor should fit flush against the motor
(Figure 15-18, Page 15-14).
2. Position retaining plate (23) over motor speed sensor and align the three retaining plate holes with motor end
shield holes. Install three retaining screws (24) (Figure 15-18, Page 15-14).
3. Reconnect the three-pin connector (22) (Figure 15-18, Page 15-14).
4. Reconnect battery cables (positive cable first) and tighten to 110 in.lb (12.4 N-m). Coat terminals with Batter
Protector Spray (Club Car Part No. 1014305) to minimize corrosion. Place Tow/Run switch in the RUN position
(Figure 15-1, Page 15-2).
Page 15-14 1998/1999 PowerDrive Plus Maintenance and Service Supplement
23
24
Figure 15-18 Installing the Motor Speed Sensor
22
21
Motor Speed Sensor
10