International HS 2.8L Service Manual page 95

Engine Timing
TIMING HOUSING
Removal
1. Remove distribution belt and toothed pulleys,
see DISTRIBUTION BELT - Removal.
2. Remove fuel injection pump, see FUEL
INJECTION PUMP Removal.
3. Remove crankshaft gear, see CRANKSHAFT
GEAR- Removal.
4. Remove oil pan, see ENGINE OIL PAN
Removal.
5. Remove oil suction pipe.
6. Remove timing housing fixation bolts.
7. Remove timing housing with gasket.
8. Remove all gasket material from contact
surfaces.
Reinstallation
1. Install guide prisoners to position gasket.
2. Install a new gasket, on guide prisoners in
engine block.
3. Align oil pump grooves with crankshaft
grooves.
4. Install timing housing on the block, taking
care to do not damage oil seal.
5. Fix bolts with correct length in the positions
where guide prisoners were not installed.
6. Remove guide prisoners, installing on its
places bolts with correct size.
7. Tighten all bolts according to specification.
8. Install oil suction pipe.
9. Install oil pan, see ENGINE OIL PAN
Installation.
10. Reinstall fuel injection pump, see FUEL
INJECTION PUMP Reinstallation.
11. Reinstall teeth pulleys, crankshaft gear and
belt.
9 4
International HS 2.8L
INTERNATIONAL ENGINES
Service Manual - 8120081 - 05/02