International HS 2.8L Service Manual page 80

International HS 2.8L
4. Check for cracks and remove crankshaft
magnetization.
5. Clean the lubrication holes.
6. Check with micrometer main journals and
crankpins length, see TECHNICAL
SPECIFICATIONS - Crankshaft.
7. Check again crankshaft main journals
eccentricity.
8. Check main journals and crankpins fillets
with caliper.
9. To balance, remove material from crankshaft
arm sides. In case of part stock, apply
antioxidant oil immersion.
10. Before assembly, wash crankshaft with water
at 80 °C (176 °F) in agitation immersion
bathing and dry with air.
Assembly
1. Clean shells housing on the block and
bearings caps. Check if engine block
lubrication galleries are not obstructed.
2. Assembly upper and lower shells on engine
block and bearing caps, correctly positioning
locks.
INTERNATIONAL ENGINES
8120081 - 05/02 - Service Manual
Crankshaft
7 9