International HS 2.8L Service Manual page 45

Lubrication System
Assembly
1. Lubricate new filter seal with clean engine oil.
2. Screw manually the filter until the sealing ring
touches the surface, manually tighten ½ turn
more, without tightening excessively.
OIL COOLER
Removal
1. Drain cooling system.
2. Remove water inlet and outlet hoses from the
cooler.
4. Disconnect pressure switch.
5. Loosen fixation bolts and remove lubricant oil
filter head complete with the gasket.
Installation
1. Clean contact surfaces.
2. Reinstall it with a new gasket.
3. Fix with bolts, tightening them according to
specification.
4. Reinstall pipes and reconnect pressure
switch.
LUBRICANT OIL PAN
Removal
1. Drain engine oil.
2. Loosen oil pan fixation bolts and use a sharp
knife, break the adhesive around oil pan
flange.
3. Remove bolts in the inverse of the tightening
sequence and remove oil pan.
4 4
International HS 2.8L
INTERNATIONAL ENGINES
Service Manual - 8120081 - 05/02