International HS 2.8L Service Manual page 57

Cylinder Head
Reinstallation
1. Install new gasket on manifold prisoners.
2. Install exhaust manifold and fix it with the two
upper and the three lower central nuts.
3. Tighten exhaust manifold fixation nuts
according to specification.
ROCKER ARM
Removal
1. Loosen rocker arm shaft set fixation nuts
from the edges to the center in 3 steps.
2. Remove the set.
3. Remove camshaft push rods marking them
to reinstall in the same position later.
5 6
International HS 2.8L
INTERNATIONAL ENGINES
Service Manual - 8120081 - 05/02