International HS 2.8L Service Manual page 100

International HS 2.8L
3. Check eccentricity to do not exceed from
0,05 mm to 0,07 mm. If eccentricity is
excessive, remove flywheel and check again
for irregularities on flywheel, crankshaft and
guide thrust surfaces.
4. Check with dial indicator gauge, concentricity
between flywheel diameter and crankshaft.
5. Reinstall in the inverse order of the removal,
install the fixation bolts, using Scotch Grip
and tighten with 60 Nm + 30°.
Flywheel housing
Removal
1. Remove flywheel, see FLYWHEEL Removal.
2. Remove the flywheel housing support four
bolts.
3. Loosen the six central bolts and remove
flywheel housing.
Reinstallation
1. Clean engine block and remove the excess
of liquid gasket (Loctite 5900) from the block.
2. Apply a 4 mm fillet of Loctite 5900 on flywheel
housing.
3. Install housing on engine block and fix it with
bolts according removed and tighten
according to specification, see TECHNICAL
SPECIFICATIONS.
INTERNATIONAL ENGINES
8120081 - 05/02 - Service Manual
Flywheel
9 9