International HS 2.8L Service Manual page 39

Fuel System
5. Install nozzle-holder set with the return outlet
turned outside.
6. Fix it with the plate and nut, tightening
according to specification.
Note: The fixation plates are slightly curved and must be installed with the convex side
upwards.
7. Install return pipe with only one copper
washer under the head of the banjo bolt and
two copper washers between the nozzle-
holder set and the banjo. Tighten the banjo
bolt according to specification.
8. Install high-pressure pipe, tightening the
union nuts according to specification.
TIMING
1. Externally clean the engine. Remove valves
cover, its gasket and breather pipe.
2. Remove high-pressure pipes set from
nozzle-holders to fuel injection pump.
3. Remove fuel injection pump inspection cover
from timing housing cover, complete with
gasket.
4. Install tool nr. 8130632 in flywheel housing.
3 8
International HS 2.8L
INTERNATIONAL ENGINES
Service Manual - 8120081 - 05/02