International HS 2.8L Service Manual page 46

International HS 2.8L
Installation
1. Clean oil pan contact surfaces, timing
housing and engine block.
2. Install new liquid gasket (LOCTITE 5900).
3. Fix oil pan to the block with bolts according to
the illustrated tightening sequence, tightening
them according to specification.
OIL SUCTION PIPE
Removal
1. Remove oil pan, see OIL PAN - Removal.
2. Remove pipe support fixation bolts.
3. Remove pipe flange bolt and oil pump
connection.
4. Remove oil suction pipe.
5. Close oil inlet duct in the timing housing,
avoiding dirt penetration.
Reinstallation
1. Reinstall oil suction pipe, installing a new
sealing "o" ring in pump connection.
2. Apply Loctite 242 in the two bearing cap
bolts. Tighten them according to
specification.
3. Install bolts in pipe flanges and tighten them
according to specification.
4. Reinstall oil pan, see OIL PAN - Installation.
INTERNATIONAL ENGINES
8120081 - 05/02 - Service Manual
Lubrication System
4 5