Table of Contents
Advertisement
OWNER'S
INFORMATION
Using Handset Wall Holder
Your fi replace equipment includes a wall holder
to store the handset. If it hasn't be installed, refer
to the instructions further on in this manual for
the installation.
Locating Lighting, Operation and Rating
Information Plate
WARNING
WARNING
!
DO NOT ATTEMPT TO TOUCH THE INFORMA-
TION PLATE WHILE THE FIREPLACE IS STILL
HOT! Let the fi replace cool fi rst before touching it.
The Lighting, Operation and Rating information is located
on a plate under the burner. To access the plate, remove the
fret or access panel, grab the plate and take it out to read it.
There is important information on both sides of the plate.
Servicing Your Fireplace
If any attention is required for your appliance, contact
your supplier quoting the model number. It will be helpful
if the appliance's serial number can also be quoted. This
number is on the rating plate, which is located under the
burner. The replacement parts are shown at the end of
this manual. Please always quote the part number and
description when requesting spare parts.
Operating Your Fireplace
There are three ways to control your fi replace.
1. Thermostatic Remote Control;
2. Wall Switch (optional);
3. Manual On/Off Switch.
The manual On/Off switch must be ON for the fi replace to
function. It can be used to shut off the fi replace in case of
emergency—see next sub-section.
The Thermostatic Remote Control can be programmed to
function automatically—see pages 9–13.
The Wall Switch (optional) can be used to turn on, off
and to increase or decrease the fl ame height—see
1265WSK—Wall Switch Kit.
NOTE: The remote control in the AUTO mode will
override the wall switch.
Thermostatic Remote
Wall Switch
Control
(optional)
8
Owner's Information
ON
OFF
Manual On/Off Switch
How to Turn Your Fireplace OFF
Familiarize yourself with each of these methods before
operating your fi replace.
Handset and Wall Switch: Press and hold the OFF button
for a second.
If the fl ames are on, they go down and you hear the valve
motor wind down. You hear a clunk and a beep indicating
that the valve has received the signal from the remote
control.
Remote control
handset
Manual ON/OFF Switch: Press the O button.
How to Ensure Your Fireplace Cannot
Be Turned ON Inadvertently
You can use one of the two following methods to ensure
that your fi replace will not turn on when you don't want it on.
First, ensure your fi replace is turned off—including
the pilot—and cold BEFORE going ahead.
• You can prevent your fi replace from lighting by
pressing the O button on the manual ON/OFF switch
on the gas valve—see image above.
• Alternately, you can remove all batteries from the
receiver as well as the battery from the handset.
Automatic Shut-Off (in certain conditions)
Your fi replace's remote control is equipped with an
automatic shut-off mechanism which is activated in certain
conditions. See page 13 in the Remote Control Operation
section for a description of this feature.
(including pilot)
Wall Switch
(optional)
ON
OFF
Manual On/Off Switch
Hide quick links:
Advertisement
Table of Contents
