Cleaning Your Fireplace - Valor LEGEND 739JLN Installation & Owner's Manual

OWNER'S
INFORMATION

Cleaning Your Fireplace

WARNING
WARNING
!
DO NOT TOUCH THE GLASS WHILE IT IS HOT!
Let the fi replace cool fi rst before cleaning it.
Important - Glass cleaning - Mineral deposits
One of the by-products of the combustion process in a
gas appliance is a mineral which can show up as a white
fi lm on the ceramic glass of the viewing door.
The composition of the deposit varies with location and
time. It is believed to be associated with the varying sulfur
content of the gas. You may have the problem intermit-
tently.
We have consulted with ceramic glass manufacturers
and they cannot offer a defi nitive solution to this problem.
Dealers have tried various cleaning products with varying
results. The following are recommendations only and are
not meant to guarantee results.
NOTE: This is a problem beyond Miles Industries'
control and is not covered under warranty.
• Clean the glass regularly as soon as you notice the
buildup (white fi lm). If the fi lm is left for a longer pe-
riod of time, it will etch into the glass. It is then much
harder, if not impossible, to remove.
• NEVER use an abrasive cleaner on the ceramic
glass. Any abrasion of the surface has the immediate
effect of compromising the strength of the glass. An
emulsion type cleaner is recommended.
• Use a soft damp cloth to apply the cleaner. Dry the
glass with a soft, dry, preferably cotton cloth. Most
paper towels and synthetic materials are abrasive to
ceramic glass and should be avoided.
• Our dealers have had good results from the products
listed below. We cannot, however, guarantee the re-
sults of these products.
•
B , P P by K
RASSO OLISH LUS
by E , W O by R
LCO HITE FF
Do not clean the glass while it is hot!
Always securely replace the window and the barrier
screen before lighting.
If broken, the glass pane may only be replaced
as a complete window unit as supplied by the
manufacturer.
If the barrier becomes damaged, the barrier shall
be replaced with the manufacturer's barrier for this
appliance.
6
Owner's Information
, C T C C
ELKEM OOK OP LEAN REME
, T W
UTLAND URTLE AX
To remove the window for cleaning:
1. Unhook the front with barrier screen.
2. On the window,
turn each bolt a
quarter turn to
disengage the
bolt pin.
3. Gently pull the
bottom of the
window outward
and unhook it
from the fi rebox's
opening frame.
4. Set the window
aside in a safe place to avoid damage.
Clean the window following the guidelines in this section.
Clean the trim and front with mild soap and water.
Dust the barrier screen with a soft brush.
Dust the fi rebox ceramic logs/rocks and walls with a soft
brush. Dust can also be removed from the burner using a
soft brush after removing the ceramic logs. When clean-
ing, make sure that no particles are brushed into the
slots of the burner.
To refi t the window:
1. To refi t the window,
place the window to
the fi rebox's opening
frame. Make sure
that the wider part of
the window frame is
at the bottom.
2. While you hold it,
push in and turn the
two bottom spring-
loaded bolts a quarter
turn to engage their pin.
3. Push in the top of the window against the fi rebox and
fasten the two top spring-loaded bolts a quarter turn.
4. Then, pull out the top and bottom of the window and
release it to insure the springs return it.
IMPORTANT: To ensure a safe operation, ensure that
the bolts are hooked properly to the window tabs.
5. Apply light hand pressure against the window frame
sides to bed-in the window seal.
Bottom
of window
(wider frame)