AgaMatrix WaveSense JAZZ Owner's Manual page 25

Replace Lancing Device Cap: Replace the lancing device
cap until it snaps into place.
Be careful not to touch the
exposed needle on the lancet.
Set the Lancing Level: The AgaMatrix Lanc-
ing Device offers 8 depth settings. Rotate
the dial to the desired setting as shown in
the depth indicator window. Level 1 is the
most shallow; level 8 is tlhe deepest. If you
have never lanced before, it is recommended
that you start at level 3. If necessary, set the
depth level to a deeper setting to produce
enough blood to fill the test strip (0.5 μL).
Cock the Handle: Pull the cocking handle out until it clicks.
You may have already cocked the handle accidentally while
inserting the lancet; this is OK.
The lancing device is now ready
for use.
[2] Insert an AgaMatrix
WaveSense JAZZ Test Strip:
Insert a new AgaMatrix WaveSense
JAZZ Test Strip into the strip port
of the meter. Make sure you insert
the test strip, with the contact bars
facing up, into the test strip port.
The meter will be activated when the test strip is fully inserted.
Note: If you do not start the test within 5 minutes, the meter will
be deactivated. To reactivate your meter, take out the unused
AgaMatrix WaveSense JAZZ Test Strip and reinsert it into the meter.
23