AgaMatrix WaveSense JAZZ Owner's Manual page 62

Replacing the Batteries
[1] Open Battery Door: Make sure the meter is
deactivated. Turn the meter so you are looking
at the battery door. Press the battery door clip
to open. Remove the battery door. Be careful
not to misplace the battery door.
[2] Remove and Install the meter battery:
To remove the used battery, pull the appropriate
tab to pop out the battery. Install the new battery
with the positive (+) sign facing up towards you.
[3] Remove and Install the backlight
battery: To remove the used battery,
pull the appropriate tab to pop out the
battery. Install the new battery with the
positive (+) sign facing up towards you.
[4] Close Battery Door: Angle the
battery door back onto the meter and
swing down until it snaps gently into place.
Make sure that the battery door is completely
closed before using.
IMPORTANT: When the meter is deactivated
and you are replacing battery #2, the time
and date information may be lost after the
battery is removed from the meter. If this
happens, activate the meter after installing
the new battery and it will prompt you to set
the time and date.
60
CR2032
CR203 CR203 CR2032
CR2032 CR2032
CR2032
CR2032
CR2032
CR2032 CR203 CR2032