AgaMatrix WaveSense JAZZ Owner's Manual page 31

[6] Final Steps
Remove the Test Strip: Remove
the used AgaMatrix WaveSense
JAZZ Test Strip. The AgaMatrix
WaveSense JAZZ Meter will
automatically deactivate.
IMPORTANT: If you do not remove the used test strip after
3 minutes of testing, the meter will deactivate. To activate
your meter with a used test strip still in the meter, press the
CHECK ( ) button once. Do not attempt to apply blood or
control solution to an already used test strip.
Remove the Lancet: When you
have finished testing, snap off
the cap from the lancing device.
Be careful not to touch the lancet tip.
Place the lancet cover onto a hard, even surface
(such as a tabletop) with the open-end facing
up. While the lancet is still in the lancing device,
bring the lancet tip to the lancet cover to recover
the used lancet. You can then safely handle the
used lancet.
Extract the lancet from the
lancet holder cup by pulling on
the plastic collar of the lancet
(near the middle of the lancet).
Replace the lancing device cap
onto the lancing device until it
snaps or clicks into place.
29