Table of Contents
Advertisement
C. Mesh Fronts
WARNING! Risk of Burns! A decorative front is required
for this model. DO NOT operate this appliance without a
decorative front in place.
A mesh front is included with the RED60. This is the door
approved with this appliance model. It must be used.
To attach the mesh front to the appliance, use the two
mesh brackets. These brackets are mounted to the un-
derside of the top of the appliance viewing area and are
fastened to the appliance by two screws on each bracket.
See Figure 10.10. There are two hanging tabs on the
back of the mesh front assembly that are bent upward.
Engage these tabs in the slot of the brackets.
Figure 10.9 Noncombustible Surface Finishing Material 0-4 Inches Thick-Inside Fit Method
Figure 10.10 Mesh Front Installation
66
65-1/2 IN.
62-3/4 IN.
17-1/8 IN.
FIREPLACE VIEWING AREA
1-3/8 IN.
= CLEARANCE FROM VIEWING AREA TO NON-COMBUSTIBLE FINISHING MATERIAL
(INSIDE FIT METHOD)
MESH BRACKETS
MESH FRAME ASSEMBLY
Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
1-11/16 IN.
1-3/8 IN.
1-11/16 IN.
MESH FRAME ASSEMBLY
HANGING TABS
20-1/2 IN.
Advertisement
Table of Contents
