Table of Contents
Advertisement
9.
Replace side panels and secure in place by using
clips on the side of the appliance.
10. The "Infi nity" look of the media provides a perception
that there is no glass on the appliance, while
maintaining the sealed combustion of the appliance.
Figure 9. Rock Media Installed.
F. Porcelain Instructions
A Porcelain Kit is available for use with the RED60 mod-
els. Install Porcelain according to these instructions
CAUTION! Risk of Cuts or Abrasions. Wear protective
gloves and safety glasses during installation. Sheet metal
edges are sharp.
NOTICE: The installation of the porcelain kit may require
the air shutter setting to be changed. See Section 9.E of
this manual to ensure the shutter gap is set correctly before
fi ring the appliance.
Note: Optional Porcelain or Granite Kits used with lighted and
non-lighted media models must be placed in appliance before
placing glass media in the appliance.
RED60 Model Without Media
This kit contains the components necessary to install
the porcelain on RED60 models that do not have media
installed.
Kit Contents:
(1) Inner back panel. See Figure 1.
(2) Inner side panels. See Figure 2.
(2) Outside corner trim pieces. See Figure 3.
(7) Angle tabs and (7) Sheet metal screws.
See Figure 4.
(1) Rear inside base. See Figure 5.
(1) Front Inside base. See Figure 6.
(1) Outside front trim base. See Figure 7.
(4) Inside Base Mesh. See Figure 8.
Tools Required
Cordless Drill
1/4 inch hex head driver tip
Flat Blade Screwdriver
70
Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
Figure 1. Inner Back Panel.
Figure 2. Inner Side Panels.
Figure 3. Outside Corner Trim Pieces.
Figure 4. Angle Tabs with Screws.
Figure 5. Rear Inside Base Piece.
Figure 6. Front Inside Base Piece.
Figure 7. Outside Front Trim Base Piece.
Advertisement
Table of Contents
