Heat & Glo RED60 Installation Manual page 69

Figure 3. Place Rock Media
ROCK MEDIA ROCK MEDIA
PLACEMENT JIG PLACEMENT JIG
PILOT SHIELD (UNDER JIG) PILOT SHIELD (UNDER JIG)
Figure 4. Placing Rock Media in Base Pan on Top of Mesh.
ROCK MEDIA ROCK MEDIA
Figure 5. Placing Rock Media Over Pilot Shield.
5. Remove the rock media placement jig by removing the
screw as noted in Figure 4. Using the fl at rock media
pieces that were sorted out in Step 1, place one layer
over the pilot shield. See Figure 5.
6. Place the glass frame assembly back on the appliance.
Assure that there is no rock media between the glass
and the fi rebox. Rock media in this area will prevent
the glass gasket from sealing.
WARNING
Risk of Asphyxiation or Fumes.
• Place rock media according to instructions.
• Do NOT place rock media in area between glass
and fi rebox.
• Do NOT place rock media pieces in a position
that they may fall into area between glass and
fi rebox.
• Do NOT use any media other than the rock media
supplied with this fi replace.
Fireplace will not function properly.
Gas leak may occur.
BURNER PORT SLOT MUST
BE FREE OF ROCK MEDIA
SCREW SCREW
PILOT SHIELD PILOT SHIELD
Heat & Glo • RED60 Installation Manual • 2159-980 Rev. D • 11/13
Figure 6. Front Access Media Tray
7. Position the front tabs of the front access media tray
toward the glass and then place in the groove of the
glass frame. Line up the media tray so that the left and
right cut-outs fi t within the glass frame.
DO NOT REMOVE CLEAR TAPE DO NOT REMOVE CLEAR TAPE
Figure 7. Location of Clear Tape
CAUTION! DO NOT remove clear tape located on
bottom of media tray. Appliance will overheat and shut
down.
Figure 8. Placing Rock Media in Front Tray.
8. Place rock media in the front tray. For an "Infi nity" look,
the media may be placed up against the glass and
tray. This step may only be done when the fi replace is
not activated and the glass is cool.
RIGHT RIGHT
CUT-OUT CUT-OUT
DO NOT REMOVE DO NOT REMOVE
CLEAR TAPE CLEAR TAPE
69